Union Community VIRDI 3000 Especificaciones descargar pdf (Pagina 53)

AC6000

Configuration Manual 53

UNION COMMUNITY Co., Ltd. 44-3 Hyundai Topics Building, Bangi-dong,

Songpa-gu, Seoul, Korea 138-050, Tel: 82-2-6488-3000, Fax: 82-2-6488-3099,

E-Mail:[email protected], http://www.virditech.com

3.2.4.2.1. WiFi Advanced Settings

The advanced WiFi settings are used for setting the security level (encryption/authentication), tx

rate and channel. Normally the Tx Rate and Channel can remain at “Auto” unless your wireless

station is configured for a specific channel or Tx Rate. Usually you will change the channel when

there are other stations in the area, on the same channel, that interfere with the wireless

communication. Each area in this window is a pull-down combo box; select the appropriate setting

you wish to use. You should set these settings to match the configuration of your wireless router.

You should know these setting before setting the AC6000 wireless.

Wireless Router – channel, tx rate, authentication type, encryption type.

WEP Encryption Key, WPAPSK password.

Security Level – this is the authentication type (how the wireless connection is established) and

encryption type (how the data is secured when communicating). There are five levels of security.

Level 0 = none, the terminal will connect to any available station that has an open authentication

without encryption enabled or authentication type.

Level 1 = Open authentication, WEP (Wired Equivalent Privacy) – basic encryption 64 to 128bit

encryption

Level 2 = Shared authentication, WEP – shared key – 64 to 128bit encryption

Level 3 = WPAPSK authentication, TKIP encryption

Level 4 = WPAPSK authentication, AES encryption

When selecting Level 1 or 2 this window will immediately show. This is the WEP encryption

key .You will be required to enter a 13 or 5 digits Ascii Encryption key or a 10 or 26 digit Hex value.

This value should match the encryption key that is set in the wireless router. Hex values are from

0 – F. Ascii values can be any key value. If a value is already entered it will show ‘*’. You can

press Done to finish, Del to delete (backspace) or CAPS to change the case from A to a, B to b,

etc.

Ascii 13 digit example = ‘ac6000test123’

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 118 119

Sin comentarios

Union Community VIRDI 3000 Especificaciones Pagina 53